The 12 Best Fiat 500 Replacement Key Cost Accounts To Follow On Twitter

Fiat van keys 500 Replacement Key Fob

It's possible to replace the battery if your 500 remote key fob is not working. If you replace the battery, but it doesn't work, the problem may be somewhere else.

United Locksmith specializes in the production of new keys for classic automobiles. We have all of the tools and accessories needed to perform this service.

Dead Coin Battery

A dead battery is the main reason for your fiat spare key 500 keyfob not locking or unlocking the doors. The key fob contains an in-built battery which will quickly drain if it is not used often enough. If your remote starts to show signs like a loss of range, or has stopped working or not responding, then the battery could be dead.

The battery inside the key fob is held in place with metal clips that retain it. If the clips are not tight, they can cause problems with the contact, which can stop your remote to receive power. With a small flathead screwdriver, push the retaining clip outwards to remove the current battery and insert a new one. Use a battery that has the same voltage, size and specifications as the original.

The key fob could also become corroded or damaged through exposure to water. Even a brief bath in soapy, warm water can damage the chip. It's best to keep your key fob in a dry area.

Water Damage

Damage to your water supply could be the reason behind your key fob's not functioning properly. The rubber seals on key fobs prevent them from being damaged by a light splash or drizzle of water. However, it's crucial to keep your keys out of the ocean, washing machine, and pool.

The key fob comes with an electronic chip that sends a signal car's immobilizer system. The chip allows the 500 to start and lock. If it gets wet it will not function.

You can clean the internal electronics of your key fob with isopropyl Alcohol or an electronic cleaner to determine whether they're still in good condition. It is recommended to replace the key fob if it's submerged in salt water rather than try to repair it yourself.

Although a replacement fob may cost a bit of money, it's much cheaper than paying for your Fiat 500 to be towed to the dealer for repair! You can also do it yourself with a few simple steps. Just make sure you have the correct type of battery before you attempt to open your key fob. There are step-by-step directions for any car keyfob online.

Faulty Chip

The chip in the key fob communicates with the immobiliser of your car to ensure that the vehicle will only start when correct keys are used. If the chip is damaged or corrupted in any way it will not start.

A damaged chip could occur due to many reasons, but the most common reason is water damage or an unresponsive battery. Regardless of the reason, it is recommended to delegate the work to a locksmith as they can replace the chip fast and at a reasonable cost.

If your key fob will not work after being exposed to water that is clean from the tap or rain take the battery off. Wipe down the electronic component with paper towels. If the key fob does not work, there's the possibility that it's malfunctioning components and need to be replaced.

Some people will visit their dealer if they require an entirely new fiat ducato key programming fob. But, this can be expensive. If you're seeking a cost-effective method to get your Fiat key fob repaired Look no further than United Locksmith. We have the tools and experience needed to fix your Fiat fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs transmit a signal up 50 feet to the vehicle, which will open and lock the doors (and start the vehicle in case of automatic transmissions). However, there are some things that could cause the fob to stop functioning. This includes a dead coin-battery, water damage, worn-out buttons, a receiver issue, signal interference, or a malfunctioning chip.

If the fob was located in the pocket of someone who has suffered extreme trauma (such as being dropped onto the floor or washed in the washer) the fob might not be able to communicate with the Body Control Module (BCM) of the car. This is because the BCM is an extremely secure system that will only accept signals from a genuine original key and not another.

You'll need to replace the fob if this occurs. A professional locksmith will handle the entire key replacement process including programming a brand new key for your 500. They can even offer an clone fob that performs exactly like the original (and costs only a fraction of what it would cost).